当前位置：首页 > 技术先锋
随动转向大灯&侧向辅助灯解析
发布时间:2014-12-12 阅读：次 [打印文章] [关闭窗口]
图6.MAX16834升压DC/DC转换器
图7.MAX16834升压-降压DC/DC转换器
MAX16834评估板
The MAX16834 evaluation (EV kit) is a fully assembled and tested surface-mount PCB designed to evaluate the MAX16834 pulse-width modulated (PWM) HB LED driver controller in a step-up (boost) configuration and optional step-up/step-down (buck-boost) operation.
The MAX16834 EV kit operates from a DC supply voltage of 7V to 28V and requires up to 5A. The MAX16834 EV kit circuit is configured to deliver up to 1A of current into series LEDs with a maximum forward voltage of 28V.
The MAX16834 EV kit features two different types of dimming control using either an analog linear input voltage or digital PWM input signal to control the LED brightness. 电感厂家This EV kit has an undervoltage lockout (UVLO) feature that disables the EV kit and overvoltage pr插件电感otection that protects the circuit under no-load conditions. The EV kit also features a active-low FLT PCB pad to monitor for open or short-circuit LE绕行电感D conditions at the LED+ and LED- PCB pads. The MAX16834 EV kit is a fully assembled and tested surface-mount board.
MAX16834评估板主要特性:
♦ 7V to 28V Wide Supply Voltage Range
♦ Configured for Boost Operation
♦ Configurable for Buck-Boost Operation
♦ 1A Output Current
♦ Analog Linear Dimming Control
♦ PWM Dimming Control
♦ Open/Short-Circuit LED Fault Indicator (FLT)
♦ Dem磁棒电感onstrates Output Overvoltage Protection
♦ Optional Load Dump Circuit
♦ Fully Assembled and Tested
图8.MAX16834评估板电路图
MAX16834评估板材料清单(BOM):
图9.MAX16834评估板元件布局图
[开关电源]带电平箝位的IR2110驱动电路本帖最后由平漂流于2016-6-1317:30编辑
“在关断期间将栅极驱动电平箝位到零电平。
在桥臂上管开通期间驱动信号使VT1导通、VT2截止，正常驱动。
上管关断期间，VT1截止，VT2栅极东芝开发出用于无线IC的宽输入电压范围、高效率 东芝公司 （TOKYO：6502）今日宣布开发出一款用于无线 IC 的芯片上开关电容直流 - 直流转换器，其效率高达 95.8%，具备 0.85V 至 3.6V 宽输入电压范围和 0.1V 至 1.9V 宽输出电压范
[稳压电源]推荐个24*365天工作的小功率稳压电源现在我想制作一个24小时*365天连续工作的一个稳定的降压电源，DC24V-DC12V，24V-36V输入，降压到稳定12V输出，输出电流在1A-1.2A.
之前我想过LM2596方案，不知道寿命如何，能不能实现全
